Note: Ingredients listed on restricted chemical lists
EC/CAS
9016-87-9
Name of the chemical
4,4'-Methylendiphenyldiisocyanat tech. (Polymeres) MDI, pMDI (in Form atembarer Aerosole, A-Fraktion)
Concentration
N/A
EC/CAS
101-68-8
Name of the chemical
4,4’-Methylenediphenyl diisocyanate
Concentration
N/A
EC/CAS
75-28-5
Name of the chemical
iso-Butan, enthält 0,1% Butadien
Concentration
N/A
EC/CAS
13674-84-5
Name of the chemical
Tris(2-chloro-1-methylethyl) phosphate
Concentration
N/A
General Information
Revision date
2020-03-11
Product name
Andersen Installation Foam
1.2.1 Relevant identified uses
Window and door installation foam
Icons in SDS
Company Information
company name
Andersen Corporation
GHS Information
Signal word
Danger
Section 2
OSHA HCS Classification
Flammable aerosols: Category 2 Gases under pressure - Liquified gas Acute toxicity: Category 4 - Inhalation Skin irritation: Category 2 Eye irritation: Category 2A Respiratory snesitization: Category 1 Skin sensitzation: Category 1 Carcinogenicity: Category 2 Speific target organ toxicity-single exposure: Category 3 Specific target organ toxicity-repeated exposure: Category 2
Signal word
Danger
Hazard statements
Flammable aerosol Contains gas under pressure; may explode if heated Causes skin irritation May cause an allergic skin reaction Causes serious eye irritation Harmful if inhaled May cause allergy or asthma symptoms or breathing difficulties if inhaled May cause respiratory irritation May cause damage to organs (Respiratory Tract) through prolonged or repeated exposure if inhaled
Prevention
Keep away from heat/sparks/open flames/hot surfaces. No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Do not breathe dust/ fume/ gas/ mist/ vapours/ spray. Wash skin thoroughly after handling. Use only outdoors or in a well-ventilated area. Contaminated work clothing should not be allowed out of the workplace. Wear protective gloves/ eye protection/ face protection. In case of inadequate ventilation wear respiratory protection.
Response
IF ON SKIN: Wash with plenty of soap and water. IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON 3/11/20 CENTER/doctor if you feel unwell. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If skin irritation or rash occurs: Get medical advice/ attention. If eye irritation persists: Get medical advice/ attention. If experiencing respiratory symptoms: Call a POISON CENTER/doctor. Take off contaminated clothing and wash before reuse.
Storage
Store in a well-ventilated place. Keep container tightly closed. Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50 °C/ 122 °F.
Disposal
Dispose of contents/container to an approved waste according to local, state & federal regulations.
Other hazards which do not result in classification
No data available 2.4. Unknown acute toxicity : No data available
