Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
14807-96-6
Name of the chemical
Talc
Concentration
N/A
EC/CAS
8052-41-3
Name of the chemical
Stoddard Solvent; Naphtha (petroleum), hydrodesulfurized heavy
Concentration
N/A
General Information
Revision date
2018-08-29
Product name
Rubberkote 1047
1.2.1 Relevant identified uses
Thermoplastic Rubber Waterproof Sealant
Manufacturer Name
Andek Corporation
Emergency telephone
1-856-786-6900, 1-800- 424-9300, +1-703-527-3887
Icons in SDS
Company Information
company name
Andek Corporation
Section 2
SECTION 2: Hazards identification
Skin: Slightly irritating. Eyes: May cause eye irritation. Inhalation: High vapor concentrations are irritating to the respiratory tract. Ingestion: Do Not ingest. Aspiration during ingestion or vomiting may cause pulmonary injury.
Hazard statements
Flammable liquid and vapor. May be harmful if swallowed and enters airways. Causes mild skin irritation. Causes eye irritation. May be harmful if inhaled.
Prevention
Do Not handle until all safety precautions have been read and understood. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Keep container tightly closed. Avoid breathing mist, vapors or spray. Do Not get in eyes, on skin, or on clothing. Wash thoroughly after handling. Do Not eat, drink or smoke when using this product. Wear protective gloves/protective clothing/eye protection/face protection. Use explosion-proof electrical/ventilating/light/equipment. Take precautionary measures against static discharge.
Response
Skin: Wash with plenty of water. Eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do, continue rinsing. Inhalation: Remove person to fresh air and keep comfortable for breathing. Ingestion: Rinse mouth. Do Not induce vomiting
Storage
Store in a well ventilated place. Keep container tightly closed. Store at temperature between 40ºF and 90ºF.
Disposal
Waste disposal should be in accordance with existing federal, state and local environmental control laws. Incineration is the preferred method.