Note: Ingredients listed on restricted chemical lists
EC/CAS
10043-35-3
Name of the chemical
Borsäure Borsäure
Concentration
N/A
EC/CAS
1303-96-4
Name of the chemical
Disodium tetraborate, anhydrous
Concentration
N/A
EC/CAS
7440-50-8
Name of the chemical
Copper
Concentration
N/A
EC/CAS
215-540-4
Name of the chemical
Tetrabordinatriumheptaoxid, Hydrat Dinatriumtetraborat, wasserfrei Orthoborsäure, Natriumsalz Dinatriumtetraboratdecahydrat Dinatriumtetraboratpentahydrat
Concentration
N/A
EC/CAS
231-159-6
Name of the chemical
Copper (nano) [INCI] (11), Colloidal Copper (nano) [INCI] (11)
Concentration
N/A
EC/CAS
233-139-2
Name of the chemical
Borsäure Borsäure
Concentration
N/A
General Information
Revision date
2014-09-01
Product name
Amtec 1028FC Brazing Rod
supplier name
Wylie, TX 75098
Manufacturer Name
Amtec Welding Products, Inc
Icons in SDS
Company Information
company name
Amtec Welding Products, Inc
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H360FD
Hazard statements
Code
Statements
H360FD
May damage fertility; May damage the unborn child
Section 2
SECTION 2: Hazards identification
EMERGENCY OVERVIEW Chemically stable and inert. Does not pose a fire hazard as shipped. Non-Flammable Flames used for brazing can ignite combustibles. Refer to American National Standard Z49.1 for fire prevention during welding. In case of fire, use NIOSH/MSHA self contained breathing apparatus.
Principle Routes of Exposure
Primary route of entry is the respiratory system. Other possible routes are eyes and/or skin contact
Potential health effects
EYES: Inert foreign body hazard only. SKIN: Rashes/irritations due to drying of the skin and/or mechanical abrasion related to skin-to-clothing contact or skin-to-skin contact. Spatter and flames from brazing may cause burns. INGESTION: Not an expected route of entry, but if ingested product could cause serious injury. INHALATION: Danger of serious damage to health by prolonged exposure through inhalation. WARNING This product contains or produces a chemical known to the State of California to cause birth defects (or other reproductive harm) and cancer. (California Health & Safety Code 25249.5 et seq.). WARNING: avoid breathing welding fumes and gases; they may dangerous to your health. Always use adequate ventilation and use appropriate personal protection equipment. CARCINOGENICITY WELDING FUMES (not otherwise specified) are considered to be carcinogenic defined with no further categorization by NIOSH and IARC. MANGANESE is listed by ACGIH as Group A4: Not classifiable as a human carcinogen. Although this product does not require a hazard warning label in all countries, we recommend that the safety advice should be observed:
Hazard pictograms
GHS07- GHS08 (flux coated rods) Boric acid Anhydrous Borax (Borax Decahydrate)
Hazard categories
Reproductive toxicity: Repr. Cat. 2
Hazard statements
May damage fertility. May damage the unborn child. H360FD May damage fertility. May damage the unborn child.
Precautionary statements
S53 Avoid exposure - obtain special instructions before use. S45 In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible). P285 In case of inadequate ventilation wear respiratory protection. P314 Get medical advice/attention if you feel unwell. P280 Wear protective gloves/protective clothing/eye protection/face protection. P202 Do not handle until all safety precautions have been read and understood. P260 Do not breathe dust/fume/gas/mist/vapors/spray. P501 Dispose of contents/container to waste treatment facility in accordance with local and national regulations. NOTE: Before using this product, contact your doctor to determine if exposure to product or use of this product will aggravate your medical conditions. Spatter and flames from brazing may cause burns and start fires.