Type RP Electrical Contact Cleaner Aerosol

Hazard statements (CLP)

H222, H229, H315, H336

Code

Statements

H222

Extremely flammable aerosol

OSHA HCS Classification

OSHA 29 CFR 1910.1200 (2012) and Canada HPR (SOR/2015-17; WHMIS 2015). Flam Aerosol 1 H222, H229 Skin Irrit. 2 H315 STOT SE 3 H336

2.2 Label elements

This product is intended for consumer use and is labeled according to CPSC guidelines and not to GHS guidelines listed below. It is safe for consumers and other users under normal and reasonably foreseeable use. The SDS contains valuable information for industrial workplace conditions.

Contains

2-methylpentane, Low boiling point naphtha, 1-methoxypropan-2-ol

Signal word

Danger

Hazard statements

H222 Extremely flammable aerosol. H229 Pressurized container: May burst if heated. H315 Causes skin irritation. H336 May cause drowsiness or dizziness

Precautionary statements

P210 Keep away from sparks, flames and hot surfaces. No smoking. P211 Do not spray on an open flame or other ignition source. P251 Do not pierce or burn, even after use. P261 Avoid breathing vapor. P271 Use only outdoors or in a well-ventilated area. P280 Wear protective gloves. P242 Use only non-sparking tools. P303 + P361 + IF ON SKIN: Take off immediately all contaminated clothing. Rinse skin with water. P353 P332 + P313 If skin irritation occurs: get medical attention. P304 + P340 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. P308 + P313 If exposed or concerned: Get medical advice. P370 + P378 In case of fire: Use water fog, foam, dry chemical or carbon dioxide for extinction. P410 + P412 Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. P501 Dispose of contents/container in accordance with local and national regulations.

2.3 Other hazards

No information available.