Blasoclean B Art. No. 4322

SECTION 2: Hazards identification

OSHA Hazardous components Sodium Metasilicate Pentahydrate (Disodium Trioxosilicate Pentahyarate) Propylene Glycol n-Propyl Ether

Non Hazardous Components

in this product are being withheld as a “trade secret” EMERGENCY & FIRST AID PROCEDURES Eye contact: Immediately flush eyes with a direct stream of water for at least 15 minutes, forcibly holding eyelids apart to ensure complete imigation of all eye and lid tissue. Get medical attention immediately. Skin contact Flush thoroughly with cool water under a shower while removing contaminated clothing and shoes. Wash clothing before reuse. Get medical attention as soon as possible Inhalation Remove to fresh air. If breathing is difficult, have trained person administer oxygen. If respiration stops, give mouth-to-mouth resuscitation. Get medical attention immediately. Ingestion Never give anything by mouth to an unconscious person. If swallowed, do not induce vomiting. Give large quantities of water or milk. If vomiting occurs, keep head below hips and airway clear and give more water. Get medical attention immediately FIRE & EXPLOSION HAZARD DATA Flash point (COC) Explosion limits Fire fighting media

Appearance/Odor

Dark brown-green liquid, distinct odor Evaporation Rate Not determined REACTIVITY DATA Stability Stable Conditions to avoid None known Incompatibility (materials to avoid) Acids, strong oxidizing agents Hazardous decomposition or byproducts: None known Hazardous polymerization or byproducts: Will not occur Doc. No. 723.539 Edition 5 Page 2 of 4 HEALTH HAZARD DATA Routes of entry: + Inhalation: Yes « Ingestion: Yes * Skin: Yes Health hazards acute: « Inhalation *Inhalation of product vapor or mist may cause coughing, sneezing or other symptoms of upper respiratory tract irritation and may resultin lung tissue damage due to corrosive effects + Ingestion: Can cause severe bumns to the mucous membranes of the digestive fract. « Skin: Contact may cause bums and tissue destruction. Exposure can cause bums, which are not immediately painful or visible « Eyes *Overexposure will cause severe bums and potential permanent damage. Health hazards chronic: *Eyes: Overexposure will cause severe bums and potential permanent damage. Carcinogenicity: None known Signs and symptoms of exposure: May cause burns or irftation of eyes, skin and respiratory tract. Inhalation may cause respiratory tract irttation Medical conditions generally aggravated by exposure: Dermatitis OSHA regulated: Corrosive WHMIS regulated: E, corrosive ENVIRONMENTAL, REGULATORY AND SUPPLEMENTAL INFORMATION NFPA Storage: mns SARA Title IIT information: + Immediate health (acute). Yes + Reactive hazard No + Fire hazard: No + Delayed health (chronic): Yes + Sudden pressure release: No Blasoclean does not contain any ingredients listed on the SARA Tile III, Section 313 List of Chernicals RCRA /Hazardous Waste: Blasoclean, as sold, does not meet the criteria of a hazardous waste as defined under 40CFR 261, in that it does not exhibit the characteristics of a hazardous waste of Subpart C, nor s it isted as a hazardous waste under Subpart D. Itis the end user's responsibility to determine the regulatory status of the waste at the time of disposal TSCA: Allingredients of Blasoclean are listed on the TSCA Chemical Substances Inventory. Clean Air Act: Blasoclean does not contain nor is it manufactured with ozone depleting substances as defined in the Federal Clean Air Act Amendments of 1990, sections 602 and 611 Canadian DSL / NDSL Information: All ingredients of Blasoclean are listed on the Canadian DSL DOT: NA1760 / Compounds, Cleaning Liquid, (disodium Trioxosilicate, Pentahydrate) PG: Ill / Hazard class: 8, corrosive / Label: Corrosive *California Prop 65: WARNING! This product contains trace amounts of the following chemicals which the State of California has found to cause Cancer, birth defects or other reproductive harm: formaldehyde Doc. No. 723539 Edition 5 Page 3 0f4 HMIS 11I® Ratings 0 1 2 3 Health, Flamability, Minimal hazard Slight hazard Moderate hazard Physical Hazard Serious hazard Severe hazard There is a new generation of HMIS® being introduced, HMIS® ll. This new system sill uses colored bars and numeric hazard ratings, but instead of ‘reactivity” t uses “physical hazard” ‘warnings, which are more in ine with OSHA defined hazards. HMIS® Il will provide employees the tools to understand and handie chemicals with a far greater degree of precision, thereby increasing the potentialfor the customer's HazCom compiance. ‘The HMIS® Il health criteria have been designed to be as compatible as possible with the definitions contained in ANSI Z129.176. They also reflect certain criteria accepted by NIOSH, U.S. EPA, and other organizations. Acte oral, dermal, and nhalation toxicity are rated on a five-tiered scale (0-4), generally with a tenfold difference. The new HMIS® Illuses two boxes to indicate health hazards: + The leftboxindicates ifthe chemical is a chronic or an acute hazard. An asterisk (*)or other designation corresponds to additional information on data sheet or separate chronic effects notiication. + The right box is used to indicate the hazard rating number. Numeric ratings are based on acute toxicity and chronic health hazard data, either from interal company data or publshed information. The HMIS® I health criteria have been designed to be as compatible as possible with the defintions contained in ANSI 2129.176. They also reflect certain criteria accepted by NIOSH, U.S. EPA, and other organizations. Acute oral, dermal, and inalation toxicty are rated on a five-tiered scale (0-4), generally with a tenfold diference between the evels. Personal Protection Index D: Face shield and eye protection, gloves and apron NFPA 704 Ratings (Under Fire Conditions) 0 ! 2 ’ ¢ Health Hazard Normal Material Slightly Fazardous Hazardous Extreme danger Dead! Fire (Flash Poinf Will not Bum >200°F 100-200°F 73-100°F <T3°F Reactivity Stable Unstable if heated Violent Chemical change Shock and Heat may May detonate detonate Notice to Reader: Information presented in this MSDS has been compiled from sources considered to be dependable and is, to the best of Blaser Swisslube Inc. knowledge, accurate and reliable, but is not guaranteed to be so. The Data in this MSDS relates only to the specific material designated herein. Blaser Swisslube Inc. assumes no legal responsibility for the use or reliance upon these data. Since conditions of use are not under our control, Blaser Swisslube Inc. makes no warranty as to the results to be obtained in using this material and we must necessarily disclaim all liability with respect to the use of any material supplied by us. Doc. No. 723539 Edition Page 4 of 4