Note: Ingredients listed on restricted chemical lists
EC/CAS
7440-50-8
Name of the chemical
Copper
Concentration
Varies
EC/CAS
7429-90-5
Name of the chemical
Aluminium
Concentration
Varies
EC/CAS
7439-92-1
Name of the chemical
Blei, massiv: [Partikeldurchmesser ≥ 1 mm]
Concentration
Varies
EC/CAS
7440-47-3
Name of the chemical
Chromium; chromic acid and its salts
Concentration
Varies
EC/CAS
7440-44-0
Name of the chemical
Carbon black
Concentration
Varies
EC/CAS
7440-02-0
Name of the chemical
Nickel
Concentration
Varies
EC/CAS
13775-53-6
Name of the chemical
Trisodium hexafluoroaluminate
Concentration
Varies processor should
General Information
Version
05
Revision date
2016-08-10
Product name
SCRAP METAL
Product Synonyms
Scrap ferrous and non-ferrous metals * Anode stubs (steel and copper), Cast iron (iron, carbon), Steel (iron, chromium, nickel), Electric motors (cast iron, copper), Brass (copper, zinc, lead) * Electric control panels (aluminum, steel, copper, polyvinylchloride insulation), Bronze (copper, tin) * Cast iron siphons (iron, cryolite, aluminum), Copper, Aluminum
1.2.1 Relevant identified uses
Recycling
Manufacturer Name
Alcoa Corporation
Emergency telephone
+1-703-527-3887, +1-800-424-9300, +1-812-853-1111, +1-613-996-6666
Icons in SDS
Company Information
company name
Alcoa Corporation
e-mail address of the competent person responsible for the Safety Data Sheet
SDSInfo@alcoa.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H317, H351, H360, H362, H373, H412
Hazard statements
Code
Statements
H317
May cause an allergic skin reaction
Section 2
SECTION 2: Hazards identification
Physical hazards
Not classified
Health hazards
Sensitization, skin Category 1 Carcinogenicity Category 2 Reproductive toxicity Category 1A Reproductive toxicity Effects on or via lactation Specific target organ toxicity following Category 1 repeated exposure
Environmental hazards
Hazardous to the aquatic environment, Category 3
Long term hazards
Hazardous to the ozone layer Not applicable
Potential health effects
The following statements summarize the health effects generally expected in cases of overexposures. User specific situations should be assessed by a qualified individual. Additional health information can be found in Section 11. The health effects listed below are not likely to occur unless processing of this product generates dusts or fumes.
Signal word
Danger
Hazard statements
May cause an allergic skin reaction. Suspected of causing cancer. May damage fertility or the unborn child. May cause harm to breast-fed children. May cause damage to organs through prolonged or repeated exposure. May form combustible dust concentrations in air. Harmful to aquatic life with long lasting effects.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dust/fume/gas/mist/vapors/spray. Wear protective gloves/protective clothing/eye protection/face protection. Avoid contact during pregnancy/while nursing. Wash thoroughly after handling. Do not eat, drink or smoke when using this product. Contaminated work clothing must not be allowed out of the workplace. Prevent dust accumulation to minimize explosion hazard. Avoid release to the environment.
Response
IF exposed or concerned Get medical advice/attention. IF ON SKIN Wash with plenty of soap and water. If skin irritation or rash occurs: Get medical advice/attention. Wash contaminated clothing before reuse. Get medical advice/attention if you feel unwell. Collect spillage.
Storage
Store in accordance with local/regional/national/international regulation. Store in a dry place. Keep dry.
Disposal
Dispose of contents/container in accordance with local/regional/national/international regulations.
2.3 Other hazards
None known.
Additional information
None. Specific hazards Non-combustible as supplied. Small chips, fine turnings, and dust from processing may be readily ignitable. Explosion/fire hazards may be present when: • Dust or fines are dispersed in air. • Chips, dust or fines are in contact with water. • Dust and fines are in contact with certain metal oxides (e.g., rust, copper oxide). • Molten metal in contact with water/moisture or certain metal oxides (e.g., rust, copper oxide). Health effects from mechanical processing (e.g., cutting, grinding) Dust Can cause irritation of the eyes, skin and upper respiratory tract. Acute overexposures Acute overexposure Can cause nausea and muscle cramps. Additional health effects from elevated temperature processing (e.g., welding, melting): Dust and fumes Can cause irritation of the eyes, skin and respiratory tract. Acute overexposure Can cause metal fume fever (nausea, fever, chills, shortness of breath and malaise). Combustion of the polyvinylchloride can generate toxic and irritating gases.
2.1 Classification of the substance or mixture
Not classified. Health hazards Sensitization, skin Category 1 Carcinogenicity Category 2 Reproductive toxicity Category 1A Reproductive toxicity Effects on or via lactation Specific target organ toxicity following Category 1 repeated exposure Environmental hazards Hazardous to the aquatic environment, Category 3 long-term hazard Hazardous to the ozone layer Not applicable Potential health effects The following statements summarize the health effects generally expected in cases of overexposures. User specific situations should be assessed by a qualified individual. Additional health information can be found in Section 11. The health effects listed below are not likely to occur unless processing of this product generates dusts or fumes.