Note: Ingredients listed on restricted chemical lists
EC/CAS
14807-96-6
Name of the chemical
Talc
Concentration
15-25
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
<1.0
EC/CAS
1333-86-4
Name of the chemical
carbon black
Concentration
0-3
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
0-2
General Information
Revision date
2022-07-01
Product name
LA611UR (All color codes)
1.2.1 Relevant identified uses
Injection molding. Intended for commercial use only
Manufacturer Name
ADVANCED COMPOSITES MEXICANA, S.A. DE C.V
Emergency telephone
+52 (449) 925 40 10, +1 (800) 424-9300
Icons in SDS
Company Information
company name
ADVANCED COMPOSITES MEXICANA, S.A. DE C.V
GHS Information
Signal word
Warning
Section 2
SECTION 2: Hazards identification
Classification (GHS-US) Hazard Classification (GHS-US): Category 4. Acute toxicity in case of ingestion, or due to high temperature which is harmful in case of contact with the skin or by inhalation of processing vapors 2.2 Pictograms and signal word: Warning
Hazard statements
H302+H312+H332 Harmful in case of ingestion, in contact with the skin or if high temperature processing vapors are inhaled. H320 It causes eye irritation due to the generation of high temperature processing vapors.
Additional information
Spilled pellets pose a slip hazard. Dust accumulation may cause explosions. High temperature processing fumes may be irritating to the eyes, nose, throat, and skin. May contain quartz and carbon black. Quartz dust has caused cancer and lung disease in workers that inhale it over an extended period of time. Animal studies suggest that carbon black may cause lung cancer through inhalation. However, inhalation of quartz or carbon black dust from this product is not deemed likely due to the plastic resin form. Maintain adequate ventilation to prevent accumulation of dust and fumes from processing. Dust created during handling or processing may be mildly irritating to the respiratory system. Keep away from sources of ignition. In solid form, this polymer product is not considered to be a health hazard, although the pellets and the dust generated from them may be mildly irritating to the skin and eyes by mechanical action. If swallowed, polymer may pose possible intestinal obstruction. 2.5 Irritancy When heated, this polymer may release fumes and/or vapors that are irritating to the eyes, nose, throat, and skin. Overexposure to fumes or vapors may also cause headache, nausea, shortness of breath, and cough.
Precautionary statements
P103 Read the label before use. P210 Keep away from heat, sparks, flames, hot surfaces and other sources of ignition. P261 Avoid breathing dust / fumes / gases / mists / vapors / aerosols. P301 + P330 + P331 In case of ingestion, rinse mouth. Do not induce vomiting. P305 + P351 + P338 In case of contact with the eyes: Rinse with water carefully for several minutes. Remove contact lenses when they are present and can be done easily. Continue with the washing. P333+P313 In case of skin irritation or rash, rinse or wash affected areas. Consult a doctor. P304+P340 In case of inhalation, transport the person outdoors and keep them in a position that facilitates breathing. P370 + P378 In case of fire, use water spray, dry chemical, foam or carbon dioxide for extinction. P403 Store in a well ventilated place. P502 Ask the manufacturer or supplier for information about recovery or recycling
2.1 Classification of the substance or mixture
temperature which is harmful in case of contact with the skin or by inhalation of processing vapors.