S-3599-0.5X

Hazard statements (CLP)

H225, H315, H319, H332

Code

Statements

H225

Highly Flammable liquid and vapour

SECTION 2: Hazards identification

2.2 Label elements

3 * 2 HEALTH 2 0 3 FLAMMABILITY - continued P284 - Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure. P338 - Eye contact: Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. P340 - Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention. P352 - Skin contact: Wash thoroughly with soap and water. Get medical attention if irritation develops or persists.

Signal word

Danger 0

Hazard statements

H225 - Highly Flammable (Flammable liquids, category 2) H315 - Irritating to skin. (Skin corrosion/irritation, category 2) H319 - Causes severe eye irritation. (Eye damage/irritation, category 2A) H332 - Harmful if inhaled. (Acute toxicity, inhalation, category 4) Precautionary Codes: P202 - This product should only by used by persons trained in the safe handling of hazardous chemicals. P233 - Store in a tightly closed container. (P404) P260 - Do not breathe vapor. P262 - Do not get in eyes, on skin or clothing. P264 - Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. - continued

2.3 Other hazards

2.2.1 - Symptom of Exposure Health/Environment Highly Flammable (Flammable liquids, category 2) Breathing high vapor concentrations may cause cyanide poisoning. Effects may be delayed. Overexposure may cause headache, breathing difficulty, irritation of eyes and throat, central nervous system disturbances and unconsciousness.

Potential health effects

Causes severe eye irritation. (Eye damage/irritation, category 2A) Irritating to skin. (Skin corrosion/irritation, category 2) May be harmful if absorbed through the skin. (Acute toxicity, dermal, category 5) Irritating to mucous membrane and upper respiratory system. Harmful if inhaled. (Acute toxicity, inhalation, category 4) May be harmful if swallowed. (Acute toxicity, oral, category 5) 2.2.3 - Routes of Entry Inhalation, ingestion or skin contact. 2.2.4 - Carcinogenicity This product is or contains a component that is classified (ACGIH, IARC, NTP, OSHA) as probably not a cancer hazard.