General Information
Revision date
2018-12-09
Product name
Steel Shot, Steel Grit
Product Synonyms
Cast Steel Shot & Cast Steel Grit
1.2.1 Relevant identified uses
Blast Media
supplier name
Abrasive Blasting Service & Supplies Pty Ltd (ABSS)
Emergency telephone
1300 727 240 (during business hours) or 0409 123 044 (after hours
Icons in SDS
Company Information
company name
Abrasive Blasting Service & Supplies Pty Ltd (ABSS)
e-mail address of the competent person responsible for the Safety Data Sheet
info@abss.net.au
Section 2
Classification (GHS-US)
Not classified
2.2 Label elements
GHS-AU Labelling – No Labelling applicable Non-GHS Hazards – Not Available
Other hazards which do not result in classification
Round or angular steel pellets used primarily for impact treatment of metallic surfaces. There are no threshold limit values (TLV) or permissible exposure limits (PEL) for cast steel abrasives CAS % ACGIH LEVEL OSHA PEL CHEMICAL NAME NUMBER WEIGHT (mg/m3) Iron – Fe 7439-89-6 >95 5 Oxide & Fume, as Fe 10 Manganese – Mn Inorganic compounds, as Mn 7439-96-5 <1.2 0.2 5 (ceiling) Fume, as Mn Silicon – Si 15 Total Dust 7440-21-3 <1.2 10 5 Respirable Fraction Carbon – C 1333-86-4 <1.2 3.5 Chromium – Cr Metal 0.5 Cr II Compounds, as Cr 7440-47-3 <0.8 0.5 Cr III Compounds, as Cr 0.05 0.5 Cr VI Compounds, Water soluble 0.01 Cr VI Compounds, insoluble Nickel – Ni Metal & other compounds, as Ni 1.5 Elemental 7440-02-0 <0.2 0.1 1 Soluble inorganic compounds 0.2 Insoluble inorganic compounds Note: This product is manufactured from recycled steel scrap and may contain hazardous materials not listed above. The following is a list of typical chemicals that may be found in recycled steel scrap (this list is not all inclusive): aluminium, antimony, arsenic, bismuth, cadmium, chromium, cobalt, copper, lead, magnesium, molybdenum, nickel, phosphorus, potassium, selenium, sodium, sulfur, tin, vanadium, zinc. There is no applicable statutory or recommended occupational exposure limits for cast steel abrasives. However, operations that elevate the temperature of the product or the dust to above its melting point, generate metal fumes and result in the breaking down of the product into dusts may present hazards. These operations should be performed in well-ventilated areas. The major exposure hazard is inhalation. Inert of Nuisance Dust: OSHA PEL: Respirable Fraction: 5 mg/m3 Total Dust: 15 mg/m3 Carcinogenicity: Chromium and Nickel are confirmed carcinogens according to ACGIH Carbon and Nickel are potential occupational carcinogens according to the NIOSH Pocket Guide to Chemical Hazards