Capmul POE-O

Hazardous Ingredients

OCCUPATIONAL EXPOSURE LIMITS INGREDIENT CAS NO. % EXPOSURE LIMITS None

Health hazards

DATA SKIN No evidence of adverse effects from available information. EYES Not expected to cause serious irritation. INGESTING No evidence of adverse effects from available information. INHALING Vegetable oil mists are classified as "nuisance particulates" by the American Conference of Governmental Industrial Hygienists (no health effects reported). SECTION 4 FIRST AID ON SKIN Wash with soap and warm water. IN EYES Immediately flush with large quantities of water for at least 15 minutes and contact a physician. INGESTED If gastrointestinal discomfort is encountered, contact a physician. INHALED Remove victim to fresh air. SECTION 5 EMPLOYEE PROTECTION RESPIRATORY In the presence of vegetable oil mists or dusts, use of a NIOSH/OSHA approved mask and/or respirator is recommended. VENTILATION Local, if necessary to control dust or fumes from hot material. EYES Chemical splash goggles are recommended. HANDS Neoprene type for hot oil. SECTION 6 PHYSICAL DATA BOILING Not determined VAPOR <1 mmHg @ 25C POINT PRESSURE VAPOR >1 EVAPORATION Nil DENSITY (Air = 1) RATE (N-Butyl Acetate = 1) SPECIFIC 1.08 @ 77F MELTING Not determined GRAVITY (Water = 1) POINT SOLUBILITY Soluble VISCOSITY Not determined

Appearance/Odor

Yellow to amber liquid with mild odor. SECTION 7 REACTIVITY DATA STABILITY Stable INCOMPATIBILITY Strong oxidizing agents. MATERIAL TO AVOID CONDITIONS High temperatures near flash point. TO AVOID HAZARDOUS Will not occur. HAZARDOUS Carbon monoxide POLYMERIZATION DECOMPOSITION dioxide. SECTION 8 FIRE & EXPLOSION DATA FLASH POINT >300F (COC) FLAMMABLE No data LEL NA LIMITS available. UEL NA EXTINQUISHING Drychemical or waterspray or waterfog, carbon dioxide, foam or sand/earth. MEDIA SPECIAL FIRE Treat as fat or oil fire. Do not use heavy stream of water. Fatty material will float and splatter surrounding area. FIGHTING PROCEDURES UNUSUAL FIRE & None. EXPLOSION HAZARDS SECTION 9 SPILL OR LEAK PROCEDURES Stop spill at source, dike area of spill to prevent spreading. Pump Liquid to salvage tank. Absorb liquid on solid absorbent material and shovel into containers. Prevent run-off to sewers, streams or other bodies of water. Wash floors with detergent and rinse with hot water to prevent slipping. SECTION 10 WASTE DISPOSAL METHOD Incineration is the recommended disposal method for all chemical wastes. Material collected on absorbent material may be landfilled in accordance with all applicable Local, State and Federal Regulations.