Note: Ingredients listed on restricted chemical lists
EC/CAS
215-540-4/1303-96-4
Name of the chemical
Disodium tetraborate, anhydrous
Concentration
0.375%
General Information
Revision date
2013-07-17
Product name
ARCHITECT B12 Low and High Control
CAS No.
1303-96-4
1.2.1 Relevant identified uses
For In Vitro Diagnostic Use
1.2.2. Uses advised against
No further relevant information available
supplier name
Abbott Diagnostics
Icons in SDS
Company Information
company name
Abbott Diagnostics
e-mail address of the competent person responsible for the Safety Data Sheet
MSDS-support@Abbott.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H360
Hazard statements
Code
Statements
H360
May damage fertility or the unborn child
Section 2
CLP CLASSIFICATION
Repr. 1A H360 May damage fertility or the unborn child.
EU Classification
Directive 67/548/EEC or Directive 1999/45/EC None
Classification system
The classification is in alignment with current European regulations. It incorporates information from technical literature and information provided by supplier companies.
2.2 Label elements
Labelling according to Regulation (EC) No 1272/2008: The product is classified and labelled according to the CLP regulation.
Signal word
Danger
Hazard statements
H360 May damage fertility or the unborn child.
Precautionary statements
P201 Obtain special instructions before use. P202 Do not handle until all safety precautions have been read and understood. P281 Use personal protective equipment as required. P308+P313 IF exposed or concerned: Get medical advice/attention. P501 This material and its container must be disposed of in a safe way.
Additional information
Refer to section 15 for labelling per Directives 67/548/EEC or 1999/45/EC. EUH032 Contact with acids liberates very toxic gas.
Principle Routes of Exposure
For bloodborne pathogens and potentially infectious materials: - non-intact skin - mucous membranes (which includes, but is not limited to, the lining of the nose, mouth and throat) - parenteral contact (e.g. by injection, puncture)
2.3 Other hazards
This product contains human-sourced components. No known test method can offer complete assurance that products derived from human sources will not transmit infection. Therefore, all human-sourced materials should be considered potentially infectious.
PBT Substances
Not applicable
vPvB Substances
Not applicable *
