Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
General Information
Revision date
2019-03-05
Product name
ARC EG-1 (Part C)
1.2.1 Relevant identified uses
ARC Polymer Composite. Repair damage caused by impact, abrasion, erosion or corrosion. Rebuild worn areas. Fill holes and cracks
supplier name
A.W. CHESTERTON COMPANY
Icons in SDS
Company Information
company name
A.W. CHESTERTON COMPANY
e-mail address of the competent person responsible for the Safety Data Sheet
ProductMSDSs@chesterton.com, customer.service@chesterton.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H350i, H372
Hazard statements
Code
Statements
H350i
May cause cancer by inhalation
Section 2
EU Classification
29 CFR 1910.1200 / WHMIS 2015 / GHS Carcinogenicity, Category 1A, H350i Specific target organ toxicity – repeated exposure, Category 1, H372 (lungs, inhalation) 2.1.2. Australian statement of hazardous nature Hazardous according to criteria of Safe Work Australia.
Additional information
For full text of H-statements: see SECTIONS 2.2 and 16. None
Signal word
Danger
Hazard statements
H350i May cause cancer by inhalation. H372 Causes damage to the lungs through prolonged or repeated exposure by inhalation.
Precautionary statements
P201 Obtain special instructions before use. P202 Do not handle until all safety precautions have been read and understood. P260 Do not breathe dust. P264 Wash hands thoroughly after handling. P270 Do not eat, drink or smoke when using this product. P280 Wear eye protection. P308/313 IF exposed or concerned: Get medical advice/attention. P405 Store locked up. P501 Dispose of contents in accordance with local, regional and national regulations.
2.3 Other hazards
The safety and health hazards are detailed separately by part. The final cured material is considered nonhazardous. Upon machining, refer to the precautions in the safety data sheets for Part A, Part B and Part C.
