ProSpec Premium Patch 200

SECTION 2: Hazards identification

The most immediate and likely hazards are burns from dust in the eye. When the product is mixed with water, it will form an alkaline solution, which can cause skin irritation. Dust from the product is irritating to breathe. Prolonged overexposure to dust from the product is harmful to breathe, because it will contain crystalline silica.

Signal word

DANGER This product has been evaluated according to GHS and 29CFR1910.1200, Appendix A. It is categorized as a Health Hazard Carcinogen Category 1A, because it contains crystalline silica (quartz). It is categorized as a Health Hazard (serious eye damage/eye irritation - Category 1 and skin irritation – Category 2) because it contains Portland cement. Applicable hazard statement(s) based on cement content Causes severe skin burns and eye damage. May cause an allergic reaction. May cause respiratory irritation. Applicable hazard statement(s) based on crystalline silica content May cause cancer from inhaling dust. Causes damage to respiratory system (silicosis) through prolonged or repeated exposure to inhaled dust.

Prevention

Do not breathe dust. Wash thoroughly after handling. Wear protective gloves/clothing and eye/face protection (water resistant protective gloves; goggles recommended to prevent any dust in eyes). Do not handle until all safety precautions have been read and understood. Do not eat, drink or smoke when using this product.

Response

IF INHALED: Remove person to fresh air and keep comfortable for breathing. Immediately call a poison center/doctor. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a doctor if any eye irritation or discomfort develops. IF ON SKIN: Take off immediately all contaminated clothing. Rinse skin with plenty of water. Wash contaminated clothing before reuse. If skin irritation occurs, get medical attention. IF SWALLOWED: Rinse mouth. Do NOT induce vomiting. Immediately call a poison center/doctor. If exposed or concerns, or if you feel unwell: Get medical advice.

Storage

Store locked up, in a dry location, in original labeled packaging.

Disposal

Dispose of contents/container in accordance with local/state/national regulations.

2.3 Other hazards

Exposure may aggravate those with pre-existing eye, skin, or respiratory conditions or illness.

HMIS® ratings

Health: 3* Fire: 0 Reactivity: 0

Hazard statements

0 = minimal, 1 = slight, 2 = moderate, 3 = severe, 4 = extreme HMIS® is a registered trademark of the National Paint and Coatings Association Section 3: Hazardous Ingredients/Composition Ingredient Typical Percentage CAS # Silica Sand (as quartz) ............................. 40-70% 14808-60-7 Cement Alumina Chemicals ..................... 10-30% 65997-16-2 Portland Cement ........................................ 7-13% 65997-15-1 Lithium carbonate ...................................... 0.1-1% 554-13-2 *Specific chemical identities and concentrations withheld as trade secret. They are available upon request to health professionals, employees and their designated representatives in accord with 29CFR1910.1200(i).