Note: Ingredients listed on restricted chemical lists
EC/CAS
24937-78-8
Name of the chemical
ethylene-vinyl acetate copolymer wax
Concentration
N/A
EC/CAS
6683-19-8
Name of the chemical
pentaerythritol tetrakis[3-(3,5-di-tert-butyl-4-hydroxyphenyl)-propionate]
Concentration
1 - 10
EC/CAS
108-05-4
Name of the chemical
Vinylacetat (944/2013)
Concentration
< 2
General Information
Version
42.00
Revision date
2024-02-01
Product name
3M Hot Melt Adhesive 3764-AE, 3764-PG, 3764-TC, 3764-Q, 3764-B
1.2.1 Relevant identified uses
Adhesive, hot-melt adhesive
supplier name
3M
Manufacturer Name
3M
Emergency telephone
1-800-364-3577, (651) 737-6501
Icons in SDS
Company Information
company name
3M
GHS Information
Signal word
Warning
Section 2
SECTION 2: Hazards identification
Hazard classification Carcinogenicity: Category 2
Signal word
Warning
Hazard statements
Suspected of causing cancer.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves.
Response
IF exposed or concerned: Get medical advice/attention.
Storage
Store locked up.
Disposal
Dispose of contents/container in accordance with applicable local/regional/national/international regulations.
Additional information
Avoid contact with hot extruded molten material or applicator tip. Avoid direct eye exposure to vapors. In case of eye/skin contact with molten material, immediately flush with cold water and cover with a clean dressing. Do not attempt to remove molten material. Have burn treated by a physician. May cause thermal burns.
2.1 Classification of the substance or mixture
Carcinogenicity: Category 2. 2.2. Label elements Signal word Warning Symbols Health Hazard | Pictograms Hazard Statements Suspected of causing cancer. Precautionary Statements Prevention: Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves. Response: IF exposed or concerned: Get medical advice/attention. Storage: Store locked up. Disposal: Dispose of contents/container in accordance with applicable local/regional/national/international regulations. Supplemental Information: Avoid contact with hot extruded molten material or applicator tip. Avoid direct eye exposure to vapors. In case of eye/skin contact with molten material, immediately flush with cold water and cover with a clean dressing. Do not attempt to remove molten material. Have burn treated by a physician. May cause thermal burns. SECTION 3: Composition/information on ingredients Ingredient C.A.S. No. % by Wt Ethylene-Vinyl Acetate Copolymer 24937-78-8 < 65 Trade Secret * Naptha (Petroleum), Llight Steam-Cracked, 68132-00-3 < 40 Trade Secret * Debenzenized, Polymers, Hydrogenated Hydrocarbon Resin Mixture