Note: Ingredients listed on restricted chemical lists
EC/CAS
75-28-5
Name of the chemical
iso-Butan, enthält 0,1% Butadien
Concentration
7 - 13
EC/CAS
108-88-3
Name of the chemical
Toluene
Concentration
1 - 5
General Information
Version
6.01
Revision date
2026-07-14
Product name
3M Hi-Strength Laminating 92 Cylinder Spray Adhesive (Clear or Red)
1.2.2. Uses advised against
Adhesive
supplier name
3M Canada Company
Emergency telephone
1800 364 3577
Icons in SDS
Company Information
company name
3M Canada Company
Hazard Codes
Hazard statements (CLP)
H315, H319, H336, H360, H370
Hazard statements
Code
Statements
H315
Causes skin irritation
H319
Causes serious eye irritation
H336
May cause drowsiness or dizziness
H360
May damage fertility or the unborn child
H370
Causes damage to organs
Section 2
SECTION 2: Hazards identification
Classification of the substance or mixture Chemicals Under Pressure: Category 1 Skin Corrosion/Irritation: Category 2 Serious Eye Damage/Irritation: Category 2A Reproductive Toxicity: Category 1B Specific Target Organ Toxicity (single exposure): Category 1 Specific Target Organ Toxicity (single exposure): Category 3 Simple Asphyxiants: Category 1
Hazard pictograms
Flame |Gas cylinder |Exclamation mark |Health Hazard |
Hazard statements
Extremely flammable chemical under pressure: May explode if heated. Causes skin irritation. Causes serious eye irritation. May damage fertility or the unborn child. May cause drowsiness or dizziness. May displace oxygen and cause rapid suffocation. Causes damage to organs: cardiovascular system.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Do not spray on an open flame or other ignition source. Do not breathe vapor or spray. Wash exposed skin thoroughly after handling. Do not eat, drink or smoke when using this product. Use only outdoors or in a well-ventilated area. Wear protective gloves and eye protection. In case of inadequate ventilation wear respiratory protection.
Response
IF ON SKIN Wash with plenty of soap and water. IF INHALED Remove person to fresh air and keep comfortable for breathing. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. IF exposed or concerned Call a POISON CENTER or doctor. Specific treatment (see Notes to Physician on this label). If eye irritation persists or if skin irritation occurs Get medical advice. If experiencing respiratory symptoms Call a POISON CENTER or doctor. Take off contaminated clothing and wash it before reuse. In case of fire: Use a fire fighting agent suitable for flammable liquids such as dry chemical or carbon dioxide to extinguish. Stop leak if safe to do so. In case of leakage, eliminate all ignition sources.
Storage
Store in a well-ventilated place. Keep container tightly closed. Store locked up. Protect from sunlight.
Disposal
Dispose of contents and container in accordance with applicable local, regional, national, and international regulations. Notes to Physician: Exposure may increase myocardial irritability. Do not administer sympathomimetic drugs unless absolutely necessary.
2.3 Other hazards
None known.
2.1 Classification of the substance or mixture
Chemicals Under Pressure: Category 1 Skin Corrosion/Irritation: Category 2. Serious Eye Damage/Irritation: Category 2A. Reproductive Toxicity: Category 1B. Specific Target Organ Toxicity (single exposure): Category 1. Specific Target Organ Toxicity (single exposure): Category 3. Simple Asphyxiants: Category 1