3M Dynatron Putty-Cote 592, 593

SECTION 2: Hazards identification

2.1 Classification of the substance or mixture

Organic Peroxide: Type E. Serious Eye Damage/Irritation: Category 2A. Skin Sensitizer: Category 1B. Specific Target Organ Toxicity (single exposure): Category 1.

Hazard pictograms

Flame | Exclamation mark

Hazard statements

Heating may cause a fire. Causes serious eye irritation. May cause an allergic skin reaction. Causes damage to organs: cardiovascular system | nervous system | kidney/urinary tract | respiratory system |

Precautionary statements

General: Keep out of reach of children.

Prevention

Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Ground and bond container and receiving equipment. Keep only in original packaging. Do not breathe dust/fume/gas/mist/vapours/spray. Wear protective gloves and eye/face protection. Do not eat, drink or smoke when using this product. Wash exposed skin thoroughly after handling. Contaminated work clothing must not be allowed out of the workplace.

Response

IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists Get medical advice/attention. IF ON SKIN Wash with plenty of soap and water. If skin irritation or rash occurs: Get medical advice/attention. Take off contaminated clothing and wash it before reuse. IF exposed or concerned Call a POISON CENTRE or doctor/physician. In case of fire Use a fire fighting agent suitable for ordinary combustible material such as water or foam to extinguish.

Storage

Protect from sunlight. Store in a well-ventilated place. Store at temperatures not exceeding 32C/90F. Keep cool. Store locked up. Store separately.

Disposal

Dispose of contents/container in accordance with applicable local/regional/national/international regulations. Notes to Physician: This product contains ethylene glycol. If there is reasonable suspicion of ethylene glycol poisoning, intravenous (IV) administration with either fomepizole (preferred) or ethanol (if fomepizole is unavailable) should be considered as part of the medical management. 3M™ Cream Hardener (Red, White & Blue)

2.3 Other hazards

None known. 17% of the mixture consists of ingredients of unknown acute inhalation toxicity.