Note: Ingredients listed on restricted chemical lists
EC/CAS
868-77-9
Name of the chemical
2-hydroxyethyl methacrylate
Concentration
25-50
EC/CAS
7732-18-5
Name of the chemical
Water, distilled, conductivity or of similar purity H2O
Concentration
20-30 5-15
EC/CAS
72869-86-4
Name of the chemical
11,14-Dioxa-2,9-diazaheptadec-16-enoic Acid, 4,4,6,16-tetramethyl-10,15-dioxo, 2-[(2-methyl-1-oxo-2-propenyl)oxy]ethyl ester (31)
Concentration
3-10
General Information
Version
8.00
Revision date
2022-04-26
Product name
3M Photac Fil Quick Aplicap Liquid
1.2.1 Relevant identified uses
Dental Product, Restorative
1.2.2. Uses advised against
For use by dental professionals only
supplier name
3M Australia
Icons in SDS
Company Information
company name
3M Australia
e-mail address of the competent person responsible for the Safety Data Sheet
productinfo.au@mmm.com
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H315, H317, H319
Hazard statements
Code
Statements
H315
Causes skin irritation
Section 2
SECTION 2: Hazards identification
This product is classified as a hazardous chemical according to the Model Work Health and Safety Regulations, 2011, in accordance with applicable State and Territory legislation. Refer to Section 14 of this Safety Data Sheets for product Dangerous Goods Classification. Classification of the substance or mixture Skin Corrosion/Irritation: Category 2 Serious Eye Damage/Irritation: Category 2 Skin Sensitizer: Category 1
2.2 Label elements
The label elements below were prepared in accordance with the Code of Practice on Preparation of Safety Data Sheets for Hazardous Chemicals (Safe Work Australia, December 2011). This information may be different from the actual product label.
Signal word
Warning
Hazard pictograms
Exclamation mark |
Hazard statements
H315 Causes skin irritation. H319 Causes serious eye irritation. H317 May cause an allergic skin reaction.
Prevention
P261 Avoid breathing dust/fume/gas/mist/vapours/spray. P264 Wash thoroughly after handling. P272 Contaminated work clothing should not be allowed out of the workplace.
Response
P302 + P352 IF ON SKIN: Wash with plenty of soap and water. P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P333 + P313 If skin irritation or rash occurs: Get medical advice/attention. P337 + P313 IF eye irritation persists: Get medical advice/attention. P362 + P364 Take off contaminated clothing and wash it before reuse.
Disposal
P501 Dispose of contents/container in accordance with applicable local/regional/national/international regulations. 2.3. Other assigned/identified product hazards None known.
Other hazards which do not result in classification
None known.
2.1 Classification of the substance or mixture
Skin Corrosion/Irritation: Category 2. Serious Eye Damage/Irritation: Category 2. Skin Sensitizer: Category 1. 2.2. Label elements The label elements below were prepared in accordance with the Code of Practice on Preparation of Safety Data Sheets for Hazardous Chemicals (Safe Work Australia, December 2011). This information may be different from the actual product label. Signal word Warning Symbols Exclamation mark | Pictograms Hazard statements H315 Causes skin irritation. H319 Causes serious eye irritation. H317 May cause an allergic skin reaction. Precautionary statements Prevention: P261 Avoid breathing dust/fume/gas/mist/vapours/spray. P264 Wash thoroughly after handling. P272 Contaminated work clothing should not be allowed out of the workplace. Response: P302 + P352 IF ON SKIN: Wash with plenty of soap and water. P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P333 + P313 If skin irritation or rash occurs: Get medical advice/attention. P337 + P313 IF eye irritation persists: Get medical advice/attention. P362 + P364 Take off contaminated clothing and wash it before reuse. Disposal: P501 Dispose of contents/container in accordance with applicable local/regional/national/international regulations. 2.3. Other assigned/identified product hazards None known. 2.4. Other hazards which do not result in classification None known. SECTION 3: Composition/information on ingredients This material is a mixture. Ingredient CAS Nbr % by Weight 2-Hydroxyethyl methacrylate 868-77-9 25 - 50 Copolymer of acrylic and maleic acids 29132-58-9 30 - 50 Water 7732-18-5 20 - 30 mono- and di- hema phosphate, magnesium None 5 - 15 salt Di urethane dimethacrylate 72869-86-4 3 - 10 SECTION 4: First aid measures 4.1. Description of first aid measures Inhalation Remove person to fresh air. If you feel unwell, get medical attention. Skin contact Immediately wash with soap and water. Remove contaminated clothing and wash before reuse. If signs/symptoms develop, get medical attention. Eye contact Flush with large amounts of water. Remove contact lenses if easy to do. Continue rinsing. If signs/symptoms persist, get medical attention. If swallowed Rinse mouth. If you feel unwell, get medical attention. 4.2. Most important symptoms and effects, both acute and delayed Allergic skin reaction (redness, swelling, blistering, and itching). 4.3. Indication of any immediate medical attention and special treatment required Not applicable SECTION 5: Fire-fighting measures 5.1. Suitable extinguishing media Use a fire fighting agent suitable for the surrounding fire. 5.2. Special hazards arising from the substance or mixture None inherent in this product. Hazardous Decomposition or By-Products