3M Impregum Penta Super Quick MB Ctalyst

3M Australia

Revision date : 2024-08-12

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.
GHS07
Health risk rating 4
Safety risk rating 1
Environmental risk rating 1

Note: Ingredients listed on restricted chemical lists

EC/CAS

9003-11-6

Name of the chemical

poly(ethylene propylene) glycol

Concentration

10-30

EC/CAS

68909-20-6

Name of the chemical

Silanamine, 1,1,1-trimethyl-N-(trimethylsilyl)-, hydrolysis products with silica

Concentration

10-30

Listed in

EC/CAS

68855-54-9

Name of the chemical

diatomaceous earth, soda ash flux-calcined

Concentration

10-30

EC/CAS

13463-67-7

Name of the chemical

Reaction mass of titanium dioxide and silver chloride

Concentration

<1

EC/CAS

128-37-0

Name of the chemical

2,6-di-tert-butyl-p-cresol

Concentration

<0.5

General Information

Version

2.01

Revision date

2024-08-12

Product name

3M Impregum Penta Super Quick MB Ctalyst

1.2.2. Uses advised against

For use only by dental professionals in approved indications

supplier name

3M Australia

Icons in SDS

GHS07

Company Information

company name

3M Australia

e-mail address of the competent person responsible for the Safety Data Sheet

productinfo.au@mmm.com

GHS Information

Signal word

Warning

Hazard Codes

Hazard statements (CLP)

H315, H317

Hazard statements

Code

Statements

H315

Causes skin irritation

Section 2

SECTION 2: Hazards identification

This product is classified as a hazardous chemical according to the Model Work Health and Safety Regulations, 2011, in accordance with applicable State and Territory legislation. Refer to Section 14 of this Safety Data Sheets for product Dangerous Goods Classification.

2.1 Classification of the substance or mixture

Skin Corrosion/Irritation: Category 2. Skin Sensitizer: Category 1A.

2.2 Label elements

The label elements below were prepared in accordance with the Code of Practice on Preparation of Safety Data Sheets for Hazardous Chemicals (Safe Work Australia, December 2011). This information may be different from the actual product label.

Signal word

Warning

Hazard pictograms

Exclamation mark |

Hazard statements

H315 Causes skin irritation. H317 May cause an allergic skin reaction.

Prevention

P264 Wash thoroughly after handling. P272 Contaminated work clothing should not be allowed out of the workplace. P280E Wear protective gloves.

Response

P302 + P352 IF ON SKIN: Wash with plenty of soap and water. P333 + P313 If skin irritation or rash occurs: Get medical advice/attention. P362 + P364 Take off contaminated clothing and wash it before reuse.

Disposal

P501 Dispose of contents/container in accordance with applicable local/regional/national/international regulations. 2.3. Other assigned/identified product hazards The silicosis target organ toxicity classification is not applied because there is no potential for inhalation exposure.

Other hazards which do not result in classification

Toxic to aquatic life with long lasting effects.

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.