Note: Ingredients listed on restricted chemical lists
EC/CAS
9011-17-0
Name of the chemical
1,1-Difluorethylene-hexafluorpropene polymer
Concentration
N/A
EC/CAS
1478-61-1
Name of the chemical
4,4'-[2,2,2-trifluoro-1- (trifluoromethyl)ethylidene]diphenol, Bisphenol AF
Concentration
N/A
EC/CAS
80-07-9
Name of the chemical
bis(4-chlorophenyl) sulphone
Concentration
N/A
General Information
Revision date
2021-04-01
Product name
3M Dyneon Fluoroelastomer FC 2176
1.2.1 Relevant identified uses
Fluoroelastomer
supplier name
3M Australia
Emergency telephone
1800 097 146 (Australia only
Icons in SDS
Company Information
company name
3M Australia
e-mail address of the competent person responsible for the Safety Data Sheet
productinfo.au@mmm.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H319, H360
Hazard statements
Code
Statements
H319
Causes serious eye irritation
Section 2
SECTION 2: Hazards identification
This product is classified as a hazardous chemical according to the Model Work Health and Safety Regulations, 2011, in accordance with applicable State and Territory legislation. Refer to Section 14 of this Safety Data Sheets for product Dangerous Goods Classification.
2.1 Classification of the substance or mixture
Serious Eye Damage/Irritation: Category 2. Reproductive Toxicity: Category 1B.
2.2 Label elements
The label elements below were prepared in accordance with the Code of Practice on Preparation of Safety Data Sheets for Hazardous Chemicals (Safe Work Australia, December 2011). This information may be different from the actual product label.
Hazard pictograms
Exclamation mark | Health Hazard |
Hazard statements
H319 Causes serious eye irritation. H360 May damage fertility or the unborn child.
Prevention
P201 Obtain special instructions before use. P202 Do not handle until all safety precautions have been read and understood. P280A Wear eye/face protection. P281 Use personal protective equipment as required. P264 Wash thoroughly after handling.
Response
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P337 + P313 If eye irritation persists: Get medical advice/attention. P308 + P313 IF exposed or concerned: Get medical advice/attention.
Storage
P405 Store locked up.
Disposal
P501 Dispose of contents/container in accordance with applicable local/regional/national/international regulations. 2.3. Other assigned/identified product hazards May cause thermal burns. 3M Vapours liberated during processing may be hazardous if inhaled. Eye, nose, throat and lung irritation can occur from such vapours.
Other hazards which do not result in classification
None known.
