Note: Ingredients listed on restricted chemical lists
EC/CAS
1344-28-1
Name of the chemical
aluminium oxide
Concentration
10 - 30
EC/CAS
7732-18-5
Name of the chemical
Water, distilled, conductivity or of similar purity H2O
Concentration
10 - 30
EC/CAS
25322-68-3
Name of the chemical
polyethyleneglycol
Concentration
5 - 10
General Information
Revision date
2017-12-27
Product name
3M Marine Premium Mold and Tooling Compound, P.N. 06027
1.2.1 Relevant identified uses
Mold and Tooling Compound, Marine
supplier name
3M
Manufacturer Name
3M
Emergency telephone
1-800-364-3577 or (651) 737-6501 (24 hours
Icons in SDS
Company Information
company name
3M
Section 2
SECTION 2: Hazards identification
29 CFR 1910.1200) The label elements below were prepared in accordance with
2.1 Classification of the substance or mixture
Serious Eye Damage/Irritation: Category 1. Reproductive Toxicity: Category 2. Carcinogenicity: Category 1A. Specific Target Organ Toxicity (repeated exposure): Category 1.
Hazard pictograms
Corrosion | Health Hazard |
Hazard statements
Causes serious eye damage. Suspected of damaging fertility or the unborn child. May cause cancer. Causes damage to organs through prolonged or repeated exposure: respiratory system |
Precautionary statements
General: Keep out of reach of children.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dust/fume/gas/mist/vapors/spray. Wear protective gloves and eye/face protection. Do not eat, drink or smoke when using this product. Wash thoroughly after handling.
Response
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor/physician. Get medical advice/attention if you feel unwell.
Storage
Store locked up.
Disposal
Dispose of contents/container in accordance with applicable local/regional/national/international regulations.
